K&M - Pilot Jack Mantis X allowing gas to blow rearward

allowing gas to blow rearward like rocket exhaust

Custom built levers to your spec's are no problem

there are no weights or sliding pointers to worry about

Stainless steel construction for long‑life durability

057 Pin) PBP-G60 Punch & Base Set (50 cal) The punch and base decaps the primer from the case while providing a stable base

K&M - Pilot Jack Mantis X allowing gas to blow rearwardThe Pilot Jack is used to assist setting the pilot position to achieve the proper cut into the case shoulder. Installation: Install the Pilot Jack on the bottom edge of the Neck Turner body and tighten the clamp screw. The thumb screw aligns to the shank end of the pilot and allows for easy positioning of the pilot in the neck turner body during the set up phase.